Waxed, ironed, scraped, and brushed
Side edges set to factory or customer specifications and polished, waxed, ironed, scraped and brushed.
Stone ground structure, base and side edges set to factory or customer specifications and polished, waxed, ironed, scraped, and brushed.
Full rebase, stone ground structure, base and side edges set to factory or customer specifications and polished, waxed, ironed, scraped, and brushed.
Grind flat, full rebase, stone ground structure, base and side edges set to factory or cusomter specifications and polished, waxed, ironed, scraped, and brushed (choose a wax below).
"This tune is for skis and boards that have decided to not get tuned up properly and have been neglected for some time requiring the ski or board to be flattend before we can begin the standard tuning process."
Extra base repair with any tune, calculated by length (inches) of the base repair
Stone ground structure, shape top sheet, skyve, sand, and polish sidewalls, set and polish base and side edge bevels by Tri-One to customers specifications, wax with Swix base prep and Swix temperature specific low fluorocarbon wax, ironed, scraped, and brushed.
Complete race ski re-tune with Tri-One edger and low fluorinated wax (skis must have been race prepped by Foothills Ski Life
Stone grind includes base flattened, specific patterns for different events and snow conditions.
Includes base flattened, specific patterns for different events and snow conditions, set and polish base bevels to customers specification.
Shape top sheet, skyve, sand, and polish sidewalls
Mount ski bindings to a ski and test the torque range to customer’s indemnification chart settings.
Remount a used ski and binding, plug old holes, and test the torque range to the customer's indemnification chart settings.
Mount a ski race plate to a new ski.
Ski binding fit and torque tested to customer’s indemnification chart settings.
Customize ski boot shell by grinding to a specific location to the customer’s foot.
Customize ski boot shell by boot press to a specific location to the customer’s foot.
Conform’able by Sidas: Includes fitting and molding process and custom fitting to the ski boots.
The Sidas Custom technology enables you to have 100% customized insoles. A flat Custom insole is used as a base before being heated and moulded to get a print of your feet. They adapt to the morphology of your feet to offer you optimal comfort.
The cuff canting adjustment (lateral tilt of the cuff) enables the skier to tune the boot geometry to specific leg morphology. The objective of the canting adjustment is to reach the skier’s most natural stance on their skis, allowing smooth and easy engagement/disengagement of the ski edges.
To guarantee maximum individuality when determining the right ski boot, an exact 3D scan of the feet is carried out. This means that not only the length and width, but also the complete shape of the foot is precisely determined. An appropriate choice of the right boots can be made based on this analysis. In the Virtual Try-on the boot is then placed over the scan. Any potential pressure points are identified and visualized.
VACUUM FULL FIT enables a complete fitting of the shell through VACUUM 2Zone for maximum individuality and optimum fit. In Fischer's VACUUM FULL FIT process, the shell is heated to 80°C before you step inside the shell with the boot liner. The Cooling and Compression Pad is put on and the standing position is fixed. Fischer has developed the VACUUM Station especially for this purpose. It is the heart of the fitting process. Compressed air is used to shape the entire boot ideally to match the foot – and the boot retains this shape once it has cooled down.